Like ToolFern? Prefer us as your source on Google →

Body Fat Calculator

Estimate your body fat percentage with the trusted US Navy method, plus your fitness category, fat mass and lean mass, from a few tape measurements, right in your browser.

-
Body fat
-
Category
-
Fat mass
-
Lean mass
-
Waist-to-height ratio

Category range

EssentialAthleteFitnessAverageAbove averageObese

Measure your neck, waist and hip with a soft tape, level and snug but not tight. Prefer not to measure? Switch to the BMI method, which only needs your height, weight and age. Both are estimates, not a clinical body-composition scan and not medical advice.

Related health tools: BMI calculator (with the waist-to-height ratio), ideal weight range and daily calorie needs (TDEE).

How to use this body fat calculator

  1. Gender, pick male or female. The formula differs, and women also enter a hip measurement.
  2. Height, your standing height in centimeters.
  3. Neck, measure just below the larynx (Adam's apple), with the tape sloping slightly down at the front.
  4. Waist, at the navel for men, or at the narrowest point for women.
  5. Hip, women only, measured at the widest point around the buttocks.
  6. Weight, optional. Add it to also see your fat mass and lean mass in kilograms.

You will see your estimated body fat percentage, a fitness category, and, if you enter your weight, how many kilograms of that is fat versus lean body mass.

How the US Navy method works

The US Navy body fat formula uses the circumference of your neck and waist (and hip for women) together with your height to estimate body fat percentage. Because fat tends to gather around the midsection, the gap between your waist and neck is a surprisingly strong predictor of overall body composition. The math uses base-10 logarithms of those measurements, so small tape errors only nudge the result slightly. It is the same approach the military uses for quick, equipment-free screening, which is why it stays popular for at-home tracking. It works best when you measure the same way each time, same tape, same spots, first thing in the morning, so the trend you see reflects real change rather than measurement noise.

Reading your result

Frequently asked questions

How accurate is the US Navy body fat method?

For most people it lands within about 3 to 4 percentage points of a DEXA or hydrostatic scan, which is good for a free tape-measure method. Consistency matters more than perfection if you are tracking change over time.

Where do I measure my neck and waist?

Measure your neck just below the larynx, and your waist at the navel for men or at the narrowest point for women. Women also measure the hip at its widest point. Keep the tape level and snug but not compressing the skin.

What is a healthy body fat percentage?

Roughly 14 to 24 percent is typical for men and 21 to 31 percent for women, though athletes run lower. Essential fat is around 2 to 5 percent for men and 10 to 13 percent for women.

Does this show the waist-to-height ratio too?

Yes. When you use the US Navy method, the calculator divides your waist by your height and shows the ratio next to the body fat result. A ratio under 0.5 is the commonly suggested target. It is general guidance only, not medical advice.

Where can I check my BMI?

The BMI calculator on this site gives your BMI, the healthy weight range for your height and a waist-to-height ratio. BMI and body fat answer different questions, so many people look at both.

This tool is for general information only and is not medical advice.

Related: BMI Calculator, BMR & Calorie Calculator, TDEE Calculator.

Found this useful? Share it